SILENT KNIGHT 4720 Installationshandbuch PDF herunterladen (Seite 57)

Regency

Model 4724 Control Expander Installation Manual (P/N 150596-02, Rev. A) Revised 8/98

to activate entry lighting. The unit will be deactivated when the entry/exit delay ends or

the area is disarmed:

GET1 @$B8.1, GET1 @$B8.0, OR, PUT1 @$9D.0

4. The following example demonstrates using if/then/else logic in I/O statements. The

flag, EXEC controls execution of statements. When the flag is on (set to 1), statements fol-

lowing are executed normally. When the EXEC flag is set to 0, statements following are

not executed.

These statements will turn on the X-10 Module when Entry mode in Area 1 is activated.

When ENTRY is not activated, the X-10 Module follows Time Window #0:

EXEC = AENTRY[1]

X10[1].0 = 1

EXEC = NOT EXEC

X10[1].0 = WINSTAT[1].0

EXEC = 1.

8.17.4 Leaving the I/O Program

To exit the Programmable/Statements Menu, follow the following procedure:

■ Press the MUTE key. The display will show SAVE:NO.

■ To exit without saving the changes, just press the TEST key.

■ If you wish to save the changes to the EEPROM (electrically erasable programmable

read-only memory), press 1 for “SAVE TEST,” then press the TEST key.

8.17.5 Factory Programmed Default I/O Program

The table below shows the factory programmed default I/O program, along with an explana-

tion of what each program does.

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 81 82

Keine Kommentare

SILENT KNIGHT 4720 Installationshandbuch Seite 57